Notice: Undefined offset: 8192 in /home/cubfest/public_html/photos/include/debugger.inc.php on line 112

Notice: Undefined offset: 8192 in /home/cubfest/public_html/photos/include/debugger.inc.php on line 112
FarmallCub | Cubfest Photo Gallery - Most viewed

 FarmallCub | Cubfest Photo Gallery

Photo host for users of the FarmallCub.com forum
Home > User galleries > Stanton

Most viewed - Stanton's Gallery
AMMETER_001.jpg
9 viewsRusted old ammeter switch box. Had a large wasp nest in there.Stanton
AMMETER_002.jpg
9 viewsJust rusty and in need of a good cleaning.Stanton
AMMETER_003.jpg
9 viewsCleaned up and welded a piece to minimize the wire opening in the bottom. This should keep my little winged "friends" from building any more nests in there.Stanton
BB_002.jpg
9 viewsPieced some new sheet metal into the old openings.Stanton
BB_003.jpg
9 viewsWelded and ground down the old openings.Stanton
BB_004.jpg
9 viewsTop is marked out on sheet metal with a Sharpie pen.Stanton
BB_005.jpg
9 viewsEasier to cut the battery cable holes while it's still flat.Stanton
BB_009.jpg
9 viewsWelded the corners and ground them down. Added some "L" brackets with tie-downs.Stanton
BB_010.jpg
9 viewsReady for some primer and paint.Stanton
Finished_049.JPG
9 viewsStanton
Finished_051.JPG
9 viewsStanton
Finished_053.JPG
9 viewsStanton
Finished_054.JPG
9 viewsStanton
J_Hook_1.jpg
9 viewsMissing a J hook and spring. Formed one from 1/4" cold rolled steel rod.Stanton
J_Hook_2.jpg
9 viewsFinished J hook with spring. Found the spring at Feldman's, a farm and home store.Stanton
J_Hook_3.jpg
9 viewsInstalled J hook.Stanton
Manifold_Tap.JPG
9 viewsRented a 2" tap to redress the manifold threads. The existing exhaust pipe had stripped threads and just sat down in the manifold. All those years of wobbling around in there rounded off the manifold threads and/or filled them with black soot. First, I tried using a 2" pipe nipple, but it wouldn't grab and center itself to cut; just kept popping out even with pressure and tapping with a mallet. So, I called the rental shop and rented a 2" pipe tap. Was tough to turn at the end. But do-able.Stanton
Manifold_Threads.JPG
9 viewsThreads restored. Rental cost was $15 for 3 hours. Couldn't buy a good used manifold for that.Stanton
Nameplate_002.JPG
9 viewsOriginal nameplate. Cleaned with soap and water.Stanton
Nameplate_004.JPG
9 viewsGetting it sanded.Stanton
88 files on 5 page(s) 4